Paradigm Speaker OM-575 User Manual download pdf (Page 6)

Fig. 9d (Before wiring speakers see note on Fig. 9d – 1 and Fig. 9d – 2 below)

CONNECTING SPEAKER

Pull cables through center hole in bracket and connect speaker following the

information on Page 10.

ADJUSTING THE SPEAKER’S ANGLE OF TILT

The self-adhesive bumper pads

(included)

allow you to adjust the angle at which

your speakers sits on the wall:

• To further optimize imaging, you can tilt Left and Right speakers inward 7°

(Fig. 9d – 1) positioning the self-adhesive bumper pads marked 7°

(as shown)

• To further optimize clarity and intelligibility, you can tilt the center speaker up

7° or down 7° (Fig. 9d – 2) positioning the bumper pads marked 7°

(as shown)

• You can also mount the speakers parallel to the wall (Fig. 9d – 3) positioning

the self-adhesive bumper pads marked 0°

(as shown)

Adjustments should be done before mounting speakers to the wall:

Horizontal Position

LEFT SPEAKER RIGHT SPEAKER

Rotate speaker

before wiring!

Adjusting Tilt on Left / Right Speakers

Fig. 9d – 3

To mount all speakers parallel to wall, attach pads

marked 0°

(as shown)

ALL SPEAKERS

Mounting Speakers Parallel to Wall

Fig. 9d – 1

The above image shows top view looking toward

listening area. Pads must sit at edges closest to

on-wall display.

LEFT SPEAKER: To tilt speaker inward

, rotate

speaker 180° then attach the pads marked 7°

(as shown)

RIGHT SPEAKER: To tilt speaker inward

, simply

attach the pads marked 7°

(as shown)

CENTER SPEAKER

Tilted down

Tilted up.

Rotate speaker

before

wiring!

Adjusting Tilt on Center Speaker

Fig. 9d – 2

CENTER SPEAKER: (shown in side view) To tilt

speaker down

, attach pads marked 7°

(as shown)

To tilt speaker up, rotate speaker 180° then attach

pads marked 7°

(as shown)

POSITIONING BUMPER PADS

Perspective in images shows only one pad. Two

pads are required, positioned as shown on the

lower recessed areas

(shaded areas)

of the keyhole

slot sections

(see Inset below)

Fig. 9e

Align keyhole slots

(shown at right)

on rear of speaker with pro-

truding screw heads on bracket, then using an “in-and-down”

motion mount speaker on bracket.

Horizontal Position

keyhole slots

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

Paradigm Speaker OM-575 User Manual Page 6

Comments to this Manuals