Paradigm Monitor 90p v4 User Manual download pdf (Page 2)

IN CANADA: PARADIGM ELECTRONICS INC., 101 HANLAN RD., WOODBRIDGE, ON L4L 3P5 IN THE U.S.: AUDIOSTREAM, MPO BOX 2410, NIAGARA FALLS, NY 14302

OM-700

REV.02.97

Active

FULLY POWERED

SPEAKER SYSTEMS

PARADIGM REFERENCE

PRINTED IN CANADA

SET-UP PROCEDURE

NOTE:

The PARADIGM REFERENCE “P” nameplate on the front of your ACTIVE speaker lights

up green whenever the speaker is operational. It will also turn red indicating that you

have reached the maximum loudness capability of the speaker system – in this case

be sure to reduce the volume to avoid damaging your speakers.

1. Proceed only when you have properly completed all hook-up instructions.

2. Turn the Speaker Level Control on the back panel of your ACTIVE speaker to

approximately half volume.

3. The level control on your

Preamp/Processor or source component

now controls the

volume. If full volume cannot be reached, increase the Speaker Level Control on

the ACTIVE speaker until full volume is established. If the “P” logo turns red

reduce volume.

Use the High-Frequency Contour Control to increase (up to +2dB) or decrease (up

to -2dB) high frequency output as may be desired.

High-frequency balance adjustment allows you to compensate for rooms that may reduce

high frequencies because of absoptive furnishings – sofas, curtains, carpets, wallcoverings,

etc., or other rooms which may have more reflective surfaces and thereby tend to increase

high frequencies.

Use the Low-Frequency Contour Control to increase (up to +4dB) or decrease (up to

-4dB) low frequency output as may be desired.

Low-frequency balance adjustment allows you to compensate for speaker placement, and the

acoustics of your listening room. Speakers placed well away from back and side walls will

provide best midrange clarity with good bass balance. In some rooms, however, this may

result in too little bass. If speakers are placed closer to back and side walls, bass will tend to

increase and there could be too much bass.

6. Switch the High-Pass to “In” when

using your PARADIGM REFERENCE ACTIVE

speaker with a subwoofer. This decreases the low bass output of the speaker

thereby increasing it’s maximum playing ceiling, resulting in reduced low

frequency distortion, improved dynamic range and overall clarity at high levels.

WARRANTY

PARADIGM REFERENCE ACTIVE

speakers

described in this manual are warranted to be and

remain free of manufacturing and/or material defects for a period of 3 years from the date

of the original retail purchase. Within this specified period, repair, replacement or

adjustment of parts for manufacturing and/or material defects will be free of charge.

(Retain this manual for proof of warranty term).

Note: Thermal damage is not covered by warranty.

Limitations:

• Warranty begins on date of original retail purchase from an A

UTHORIZED

PARADIGM

EFERENCE DEALER

only. It is not transferable.

• Warranty applies to product in normal home use.

• Warranty does not apply if the product is used in professional or commercial

applications.

Warranty is Void if:

• The speaker has been abused (intentionally or accidentally).

• The speaker has been used in conjunction with unsuitable or faulty equipment.

• The speaker has been subjected to damaging signals, derangement in transport,

mechanical damage or any abnormal conditions.

• The speaker (including cabinet) has been tampered with or damaged by an

unauthorized service facility.

• The serial number has been removed or defaced.

Owner Responsibilities:

• Provide normal/reasonable operating care and maintenance.

• Provide proof of purchase (your sales receipt given at time of purchase from your

AUTHORIZED PARADIGM REFERENCE DEALER must be retained for proof of

purchase-date).

• Provide or pay for transportation charges for product to service facility.

Should servicing be required contact your nearest AUTHORIZED PARADIGM REFERENCE

DEALER, PARADIGM ELECTRONICS INC. (in Canada), AUDIOSTREAM, DIVISION OF BAVAN

CORPORATION (in the U.S.) or IMPORT DISTRIBUTOR (outside the U.S. and Canada) to

arrange, bring in or ship, prepaid, any defective unit.

PARADIGM ELECTRONICS INC. reserves the right to improve the design of any product

without assuming any obligation to modify any product previously manufactured.

This warranty is in lieu of all other warranties expressed or implied, of merchantability,

fitness for any particular purpose and may not be extended or enlarged by anyone. In no

event shall PARADIGM ELECTRONICS INC. their agents or representatives be responsible for

any incidental or consequential damages. Some jurisdictions do not allow limitation of

incidental or consequential damages, so this exclusion may not apply to you.

WARNING:

POWER CORD

GROUND IS NOT ATTACHED TO

AMPLIFIER CHASSIS

•

ALWAYS ON

•

AUTO ON/OFF

120V

60Hz

350W

LOW LEVEL INPUT

PATENTS PENDING

HIGH

PAS S

SWITCH IN

WHEN USING

SUBWOOFER

HIGH

FREQUENCY

CONTOUR

LOW

FREQUENCY

CONTOUR

BALANCED

SPEAKER

LEVEL

PARADIGM

REFERENCE

AVIS:

LE CORDON DE MISE

À LA TERRE N'EST PAS ATTACHÉ

AU BOÎTIER DE L'AMPLIFICATEUR

WARNING:

SHOCK HAZARD,

DO NOT OPEN!

AVIS:

RISQUE DE CHOC

ÉLECTRIQUE, NE

PAS OUVRIR!

MAIN

-2dB + 2dB

-4dB + 4dB

-24

-52

-50

-46

-6

-68

-66

-64

-62

-60

-56

-58

-54

-42

-38

-34

-30

-18

-12

-70

NRTL /C

LR 103255

THIS PRODUCT HAS

BEEN CERTIFIED

BY CSA

MADE IN / FABRIQUÉ AU CANADA

PARADIGM ELETRONICS INC.

ROM PREAMP/PROCESSOR

OR OTHER SUITABLE LOW LEVEL

SOURCE TO BALANCED

(XLR) INPUT.

WITCH LOW LEVEL INPUT TO

“BALANCED”.

• BALANCED (XLR) INPUT:

The Balanced input should be used if there is the potential of picking up any

exteraneous electrical noise from other sources. The use of this input requires...

1. That your Preamp/Processor (or source component) has Balanced (XLR) Outputs.

2. The use of Balanced interconnect cable with “XLR” connectors. See your dealer for

further information and recommendations.

To use the Balanced Input, switch the Low Level Input switch to the “Balanced”

position and connect the Balanced interconnect cable from your Preamp/Processor or

source component, to the Balanced (XLR) input jack on the speaker.

PARADIGM

REFERENCE

OWNERS MANUAL

1 2

Comments to this Manuals

No comments

Paradigm Monitor 90p v4 User Manual Page 2

Comments to this Manuals

Related products and manuals for Multimedia Paradigm Monitor 90p v4